Set Dialogic Telephony Board Low-Level Parameters
$dtg_parm parm=parmstring
This command allows setting of Dialogic low-level telephony-board parameters. Please consult Copia or your CopiaFacts supplier before using this command. Incorrect settings can disrupt the operation of your system and may also invalidate the PTT approval of your board.
The command is ignored if a Dialogic SC-Bus board with Telephony Channels (e.g. D/240, D/300) is not found.
The parameter on this command is used as follows:
| parmstring | a parameter specification as described below |
The parameter specification uses a keyword=value syntax with the keyword selected from the list below. Only one keyword value can be specified per command, but you may use up to 16 commands to set the values you need.
Valid keywords are as follows:
| DTG_MINPDON | Minimum pulse dial reception on |
| DTG_MINPDOFF | Minimum pulse dial reception off |
| DTG_MAXPDOFF | Maximum interdigit reception delay |
| DTG_MINIPD | Maximum pulse digit reception off |
| DTG_P_MK | Send pulse make time |
| DTG_P_BK | Send pulse break time |
| DTG_P_IDD | Send pulse interdigit delay |
| DTG_PDFLASH | Flash character |
| DTG_CABTYPE | Cable type (LIU) |
| DTG_OOFMAX | Out of frame errors, maximum (<=15) |
| DTG_FECRMAX | Max FECR error count (<=255) |
| DTG_ESECMAX | Extended superframe Err. cnt max <=15 |
| DTG_FECSMAX | Frame error count saturation |
| DTG_BPVCMAX | Bipolar violation count max <=255 |
| DTG_RDEBON | Receive debounce on value, in 10ms units |
| DTG_RDEBOFF | Receive debounce off value,in 10ms units |
| DTG_PCDEAD | Signalling dead parameter |
| DTG_RCVTOL | Low word of rcv timeout (& ack) |
| DTG_RCVTOH | Hi byte of 3 byte rcv & ack timeout |
| DTG_CODESUPR | Suppression value (b8zs,bit7 or tran |
| DTG_WINKMAX | Wink time, in 10ms units |
| DTG_REDTIME | RLOS -> red alarm transition time |
| DTG_RCOVRTM | Red alarm recovery time |
| DTG_PDPSTIM | Pulse dialing pause time |
| DTG_WINKMIN | Wink time, in 10ms units |
| DTG_WINKLEN | Wink length(xmt), in 10ms units |
| DTG_PREWINK | Pre-wink delay in 10ms units |
| DTG_CRCENABL | CRC4 switch (ENABLE or DISABLE) |
| DTG_CECRMAX | Max CRC4 error count <= 255 |
| DTG_ECRRSTTM | Err cnt register reset time in 100ms units |
| DTG_RXTXIDLE | Receive & Trnsmit idle patterns |
| DTG_SEIZESIG | Line Seizure and Response |
| DTG_DVPRMMAX | Max value of device parameter |
| DTG_SETCLK | Set the clock source |
| DTG_IDLTYP | Set the idle type |
| DTG_DSERRC | Disable error condition mask |
| DTG_ENERRC | Enable the error condition mask |
Example:
$dtg_parm DTG_RDEBON=10
Topic url:
http://www.copia.com/support/refmanual/index.html?$dtg_parm.htm
