Set Dialogic Voice Board Low-Level Parameters
$dcb_parm parm=parmstring
This command allows setting of Dialogic low-level voice-board parameters. Please consult Copia or your CopiaFacts supplier before using this command. Incorrect settings can disrupt the operation of your system and may also invalidate the PTT approval of your board.
The parameter on this command is used as follows:
| parmstring | a parameter specification as described below |
The parameter specification uses a keyword=value syntax with the keyword selected from the list below. Only one keyword value can be specified per command, but you may use multiple commands. Most time values are specified in 10ms units.
Valid keywords are as follows:
| flashchr | Flash char in dialing string |
| flashtm | Flash time 10ms units |
| pausetm | Pause time 10ms units |
| digrate | Digitizing rate in Hz |
| sch_tm | Maximum time slice given to scheduler |
| p_bk | Pulse break interval in 10ms units |
| p_mk | Pulse make interval in 10ms units |
| p_idd | Pulse dial inter-digit delay in 10ms |
| t_idd | Tone dial inter-digit delay in 10ms |
| offhdly | Offhook delay interval in 10 ms |
| r_on | Min. ring on interval in 100ms units |
| r_off | Min. ring off interval in 100ms units |
| r_ird | Delay after ring cnt is reset in 100ms |
| s_bnc | Sil. message debounce interval in 10ms |
| ttdata | Duration of DTMF digit in 10ms units |
| minpdon | Min. dur. for lc on for a valid pulse |
| minpdoff | Min. dur. for lc off for a valid pulse |
| minipd | Min. interpulse digit time for lc on |
| minlcoff | Min. dur. of lc off for CST_CUR_ON |
| maxpdoff | Max. dur. for pd make |
Example:
$dcb_parm flashchr=&
$dcb_parm flashtm=15
Topic url:
http://www.copia.com/support/refmanual/index.html?%24dcb_parm.htm
