|
$proof [UJP] |
  
|
|
$proof [UJP] |
|
Specify Job Proof and Destination
$proof phone|address [delaycode]
This command controls the sending of a job proof before the main broadcast is launched. The proof is sent to either a fax number or an e-mail address, as appropriate. If the proof command is given, the proof is scheduled immediately after the job is created.
The parameters on this command are used as follows:
| phone | The phone number to which the proof is to be sent, enclosed in double-quotes if it contains embedded blank space. |
| address | The address to which the test e-mail is to be sent. This use of the parameter is distinguished by the presence of a @ in the string. No expansion of variables takes place for this parameter, so a single @ may be used. |
| delaycode | A (positive) delay in minutes after which the job will be automatically launched if not suspended. The time runs from the completion of the proof transmission. In addition the following codes may be used: |
| 0 | The proof is sent and the launch immediately follows. |
| -1 | The job is not launched as a result of sending the proof. This is the default if the parameter is omitted. |
Default: no proof is sent
Examples:
$proof 6307788848
$proof """Steve Hersee"" <shersee@copia.com>"
Topic url: http://www.copia.com/support/refmanual/index.html?%24proof.htm