You require this release if you are using a Netaccess ISA board. Otherwise use API 4.3 and ECC 1.75
The following installation steps are needed:
| • | This release is not supported by the CopiaFacts installer but is on the CopiaFacts CD. Browse the CD using Windows Explorer. |
| • | Run BTNA162\SETUP.EXE to install ECC 1.62 to e.g. C:\BFAX. Do not reboot at the end of the SETUP. |
| • | Change directory to C:\BFAX\SERVER |
| • | Set up C:\BFAX\SERVER\BCHANMAP.CFG as in the examples below for 1T1. The first column in this table is omitted for ECC 1.62. Note that there are also some sample channel map files in the C:\BFAX\SERVER folder you may be able to use. |
| • | If you are using Windows 2000, copy NAIDRV_162.SYS from the BTNA162 folder on the CD to C:\WINNT\SYSTEM32\DRIVERS\NAIDRV.SYS, overwriting the file of that name that is there already. |
| • | Copy BTNA.T1 to BTNA.CFG. In BTNA.CFG you may need to edit the switch type and variant type - if so use the table later in this document. |
| • | Edit BTNA.CFG with Notepad to add a the following line as the line immediately following the comments at the top of the file, before the [board...] sections. (Adjust the path if not using C:\BFAX) |
bchanmap C:\BFAX\SERVER\BCHANMAP.CFG
| • | Run BTNASRV -install and either accept the default paths or edit as needed. Initially, enable the debug log file. |
| • | Run NET START BTNASERVICE. Check in the Netaccess IRP Control Panel Applet that the service is running and correctly configured (on the information page). |
| • | Go to Start | Settings | Control Panel | Services |
| • | Select BTNASERVICE and change its startup to Auto |
| • | Go to Start | Settings | Control Panel | Devices |
| • | Select Netaccess IRP Driver and change its startup to Auto |
| • | At this stage you should reboot and check that no errors are reported in the Windows Event Log. |
| • | Next install Brooktrout 4.1.1 by running \BROOKTRT\IFFBR411.EXE on the CD |
| • | The BTCONF program is run from the installer and should select default address settings |
| • | Change to the FaxFacts directory and move DIGITAL.T1 to DIGITAL.CFG |
| • | Ensure that the path to this DIGITAL.CFG file is correctly referenced in the BTCALL.CFG file which should have been placed in the FaxFacts home directory |
| • | Install the new release of CopiaFacts, and in Program Files\Copia rename F7BN.DLL to F7BN43.DLL and F7BN41.DLL to F7BN.DLL. You will need to do this for each new CopiaFacts release that you install. |
Topic url:
http://www.copia.com/support/refmanual/index.html?brooktroutapi4_1_1andecc12.htm
